Fitting an LED tube light is pretty straightforward. All LED retrofit kits come with a complete set of installation instructions.
The installation process usually involves removing the existing lamps, ballast, brackets, and sockets and restoring them. The majority of retrofit LED tube installations require minimal wiring and the ballast to regulate the lamp’s brightness as it warms up.
This process is uncomplicated and is generally a recommended step during a retrofit. To finish the work perfectly and safely, it is recommended to call a licensed electrician who can cautiously install the retrofit kit.
Both LED and fluorescent tubes are capable of outputting very bright and clean light depending on the fittings and specifications of the tubes being used.
Here, the key difference is that LEDs can generate the equivalent amount of brightness at minor wattages than the fluorescent ones. LED lamps also cause a far lower rate of energy consumption, frequent running costs, and heat generation.
The “T” in lamp terminology portrays the shape of the lamp-tubular. T5 lamps have a diameter of 5/8 of an inch and are approximately smaller than T8 lamps by 40%.
If your lights are not suitable for extreme environments or if you want to save some extra money on your electricity bills, then this might indicate that you need a T5 LED light in your house.
These tube lights offer greater efficiency and require lower wattage and hence can save you a lot in your electricity bill.
A retrofit kit usually includes brackets, screws, quarter-turn fasteners and sockets. The ballasts and bulbs required for the retrofit kit are generally sold separately. Many kits also include a reflector, that is designed particularly for the kit to effectively run light out of the fixture and land the light where it is required.
Today, LED tubes are used in a large number of homes, businesses, and civic facilities. These LED tubes are replacing the old-style fluorescent tubes for some great reasons. LED tube carries many more advantages over a fluorescent tube and some of them are as follows:
You can choose to dim the lights of LEDs manually at your convenience.
Installing an inferior quality or the wrong type of LED tube may result in premature failures and can lead to dangerous hazards like short-circuits and fire.
When choosing an LED tube light retrofit, it is recommended to go for LED tubes that are compatible with any of the electric potential configurations in a fluorescent installation.
LED tube light is generally cheaper and it has come down to a price level that competes with fluorescent lamps over these years. Over time these LED tube lights can save much more money than the traditional fluorescent lights as these LED tube lights have very low maintenance costs and can perform in a low wattage than fluorescent light. In a long run, investing in these lights can cost you much lesser.
If you want to invest in a reliable and lasting T5 LED retrofit, you can choose Sanforce. Sanforce is a leading manufacturer of LED retrofits, emergency power kits, ballasts, and drivers.
Sanforce being the leading manufacturer and distributor of emergency lighting supplies based in China manufactures and ships products globally.
Our T5 LED retrofit lightning is similar to ordinary emergency lamps and it can be switched on and off normally.
It can also easily get switched to emergency mode when the power goes off. These LED retrofits offer a Warranty of three years and there is no need for special wiring for the emergency tubes.
You can also choose to order our products in bulk according to your needs. We focus more on customer satisfaction and never compromise the quality of our products.
If you wish to make a bulk order of any of our products, Sanforce can send you a sample so that you can find a good fit for your home or office.
You can visit our official site to buy our products. To know more about us you can contact us through the contact page of our official site.
Not sure what you required for your lightining project ?
Get in touch with us for FREE consultation.